Dimensioning of parts exposed to the mechanical turning process through an application for mobile devices / Dimensionamento de peças expostas ao processo de torneamento mecânico através de uma aplicação para dispositivos móveis

Authors

  • Fernanda B. A. Freitas Brazilian Journals Publicações de Periódicos, São José dos Pinhais, Paraná
  • Esdras S. Soares
  • Fabrício L. Alves
  • Dorgival A. S. Júnior

DOI:

https://doi.org/10.34117/bjdv7n6-638

Keywords:

Mechanical Turning, Cutting Speed, Advancement, Cutting Time.

Abstract

The present article aims to study some common equations in calculations of the mechanical turning process, using active teaching-learning methodologies. Thus, this work has as main objective to develop an application to determine the various variables necessary for the dimensioning of the parts to be turned inside the machining. The expressions used in the application show the Cutting Speed, Advance per Rotation, and Cut Time. In addition to the great contribution to the teaching-learning of the user executing the application, it provides solutions to daily activities that involve these types of problems in Mechanical Engineering. From the obtained results, it was observed that the Cutting Speed, Rotation Advance and Cut Time presented modifications with variations of the properties connected to these cutting parameters.

References

Machado, A. R. et al. Teoria da Usinagem dos Materiais, 2ª ed., São Paulo: Edgard Blücher, 2011.

Ferraresi, D. Fundamentos da Usinagem dos Metais, 16ª ed., Edgard Blücher, São Paulo, 2013.

Diniz, A.E.; Marcondes, F.C.; Coppini, N.L. Tecnologia da Usinagem dos Materias, 5ª ed., São Paulo, Artliber, 2013.

PAZINI, D.L.G; MONTANHA, E.P. Geoprocessamento no ensino fundamental: utilizando SIG no ensino de geografia para alunos de 5.a a 8.a série. Anais XII Simpósio Brasileiro de Sensoriamento Remoto, Goiânia; p. 1329-1336, 2005.

BARRETO, Alcyrus Vieira Pinto; HONORATO, Cezar de Freitas. Manual de sobrevivência na selva acadêmica. Rio de Janeiro: Objeto Direto, 1998.

RECH, J.; MOISAN, A. Surface Integrity in finish hard turning of case-hardened steels. International Journal of Machine and Manufacture, 43, 2003, p. 543-550.

FERRARESI, D. Fundamentos da Usinagem dos Metais, Vol. 1, Edgard Blücher, 1970.

PIRES, F. B.; UEMURA, L. C.; ZANGHETTIN, L. Energia mecânica com ênfase em processos de usinagem – torneamento. REGRAD, UNIVEM/Marília-SP, v. 10, n. 1, p 325 - 338, outubro de 2017.

Published

2021-06-25

How to Cite

Freitas, F. B. A., Soares, E. S., Alves, F. L., & Júnior, D. A. S. (2021). Dimensioning of parts exposed to the mechanical turning process through an application for mobile devices / Dimensionamento de peças expostas ao processo de torneamento mecânico através de uma aplicação para dispositivos móveis. Brazilian Journal of Development, 7(6), 63525–63538. https://doi.org/10.34117/bjdv7n6-638

Issue

Section

Original Papers